bubblestar

OK!  Like both of you, I re-start to compile the default one first now without checking inadyn.

ckleea

On the way to your mail box

角色

The DHCP version has been compiled.
ckleea 發表於 2011-2-13 22:23

How can we have the DHCP version?

YH

bubblestar

回復 407# ckleea


   
Well received with thanks.  Mine without DHCP is under imaging.   Almost finish.

bubblestar

Just finishing upgrade to SVN490 DHCP version.  As usual, cannot log-in now.  And as uaual, I am now switch off the box and will turn it on after serveral minutes.  Hope I can go inside later on.

By the way, the LOG IN page has some new added features as below.  Think that we can assign someone other than Administrator to operate some general settings.

下載 (37.41 KB)

2011-2-13 23:19

角色

Mine always reboots whenever I attempted to login my ip01 but failed.

It seems that 590 is not very stable.

YH

bubblestar

My own version without DHCP has also just finished compiling but the file size is 8.5 MB.  I'm worrying about whether my box can accommodate the upgrade.

Other than the default (less inadyn), I added Asterisk custom settings, imap, g729, TIFF2PDF, iptables.

ckleea

回復 412# bubblestar
It is quite big. The failure to boot may be related to the firmware too big i.e. without sufficient space for the root.

My DHCP version means that during compilation, I have made change to the /persistent/etc/network.conf and /persistent/etc/asterisk/rc_org.conf to ensure dhcp = yes. It is is for me and other with a intranet lan address not in the range of 192.168.1,XX

ckleea

回復 412# bubblestar

You may de-select the g729. Other is just quite standard. However, it is the limit for the hardware. root partitiion needs a bigger size.

BTW, are you able to make the boot and successful login?

ckleea

What is the log messages what you login in via SSH?

bubblestar

Still cannot access the PBX thru GUI.

From Putty, seems no problem found.

下載 (102.24 KB)

2011-2-14 13:41

From Hyberterminal, there seems some problem there.

下載 (37.05 KB)

2011-2-14 13:41

ckleea

It may not be the problem.

Please login in and dump the log from asterisk

bubblestar

Same as YHFung, my own compiled version 490 automatically reboots itself into endless loop.  
Mine is also same as ckleea's one, it is a DHCP version but cannot log in via GUI neither.

Take a break first

ckleea

I am interested in your SSH login and asterisk log. I suspected that the space at root partition is not enough.

bubblestar

SVN437's size is 8.2MB.  Your latest SVN490 is 8.4MB and mine is 8.5MB.
I think 8.2MB to 8.3MB might be the ceiling of IP01.  

Just reflash back to SVN437.  I noticed that the process has been very smooth if we upgrade from SVN373 and then SVN437 directly.   If upgade from SVN437 to the latest SVN490, it will be a long lag and end up failure.  

Guess that we should upgrade from a lower version with more space to act as processing buffer.  Also I doubt SVN439 is still buggy.

BTW, DHCP settings help me a lot in the course of flashing the firmware.  I don't need to change so frequently of the network segment in between. A really nice feature that I have learnt how to master it now.  Thanks ckleea C-Hing。