本帖最後由 角色 於 2014-5-25 16:52 編輯
The procedure to set up a guest wireless LAN (without any password)
1. Go to the page of Network->Wifi, as shown in Figure 1.
Figure 1: Network->Wifi
2. In Figure 1, press "Add" button, it gives Figure 2.
Figure 2: Network->Wifi, Interface Configuration
3. In Figure 2, under Interface Configuration,
enter "Free WiFi" for ESSID field
create "wlan_guest" under Network, as shown in Figure 2.
4. Save and Apply
5. Goto Network->Interfaces, it gives Figure 3.
Figure 3: Network->Interfaces
6. In Figure 3, edit WLAN_GUEST, it gives Figure 4.
Figure 4: Network->Interfaces for WLAN_GUEST
7. In Figure 4, change the protocol from "Unmanaged" to "Static address", it gives Figure 5.
Figure 5: Network->Interfaces for WLAN_GUEST
8. In Figure 5, click "Switch protocol" button, it gives Figure 6.
Figure 6: Network->Interfaces, protocol using static address
9. In Figure 6, enter "10.0.0.1" for IPv4 address
10. Enter "255.255.255.0" for IPv4 netmask
11. Press "Save" command
12. Under DHCP Server, click "Setup DHCP Server" (Use the default values, start = 100, Limit = 150, Leasetime = 12h)
13. Save and apply
14. Goto Network->Firewall, it gives Figure 7.
Figure 7: Network->Firewall
15. Press 'Add", as shown in Figure 7, it gives Figure 8.
Figure 8: Netowrk->Firewall, zone forwarding
16. In Figure 8, under General Settings, add "waln_guest" to the Name field
17. Under "Covered network", tick the box for "wlan_guest"
18. Under Inter-Zone forwarding, put a tick to the box for "wan" to allow forward to destination zones.
19. Save and apply
20. Reoboot the router |
發表於 2013-3-4 01:37
| 
