Trixbox + spa3000 撥出問題

cinan032

大家好, 又是我了
這個問題找過了很多文章跟上網找了很久, 也不太明白

因為spa3000本身連的電話線已經要先按9先會聽到撥號聲
那我trixbox那裡的Dial Patterns應該要9+xxxxxxxx嗎?
但我試過用softphone撥12345678(香港電話), 不行
而打入已經試過沒問題的

ckleea

請看 this link
http://www.telecom-cafe.com/foru ... &extra=page%3D2

你需要 setup a dialplan from trixbox and spa3000 so that you can dial out after your softphone go into your trixbox.

For example in my set up

I have added this to my sip.conf

[pstn-spa3k-d1]
type = peer
secret = password
username = username
host = 192.168.xxx.xxx ; ip of SPA3000
fromuser = username
port = 5061
dtmfmode = rfc2833
qualify = yes
nat = yes
context = default
disallow = all
allow = g729
allow = ulaw
allow = alaw

When softphone dials in my asterisk, it responds with an IVR. Then I press 9+HK tel no, the asterisk will find the dialplan for pstn-spa3k-d1 for outgoing PSTN.
P.s. the context of pstn-spa3k-d1  allows my asterisk to connect to spa3000 within my network. This saves me some money and hurdles to get a FXO card within the system

I am not familiar with trixbox and so can't help you to configure.

cinan032

你的意思是一定要向voip provider申請plan嗎?
如果我只能用這條要"先按9才有撥號聲"的線行嗎?

softphone/spa3000的電話 > trixbox > spa3000 > 本地電話

謝謝你的回覆

ckleea

回復 3# cinan032

你沒有裝 sip dial out plan to SPA300

cinan032

是啊!
但是如果用HTTP digest method去完成

VoIP User 1 Auth ID: 跟trixbox的sip trunk name
VoIP User 1 Password:跟trixbox的sip trunk pw
VoIP User 1 DP: none

應該是這樣沒錯吧? 還是還有其他的設定?

那我現在應該在softphone是要:
先撥9->按call-> 按電話號碼 (例:12345678)
這樣的話按call之後就會立即斷線

還是直接912345678?
這樣子不行

ckleea

回復 1# cinan032

你的問題是否:

你想用SPA3000做PSTN trunk，透過Trixbox 打PSTN？

我現在用HTTP digest method 去完成。