New Obi config problem

ttmuskie

Just got one today and want add another rule under:

Phone port> OutboundCallRoute:

Default:
{([1-9]x?*(Mpli)):pp},{(<#:>|911):li},{**0:aa},{***:aa2},{(<**1:>(Msp1)):sp1},{(<**2:>(Msp2)):sp2},{(<**8:>(Mli)):li},{(<**9:>(Mpp)):pp},{(Mpli):pli},

After changed:
{([1-9]x?*(Mpli)):pp},{(<#:>|911):li},{**0:aa},{***:aa2},{(<**1:>(Msp1)):sp1},{(<**2:>(Msp2)):sp2},{(<**8:>(Mli)):li},{(<**9:>(Mpp)):pp},{(Mpli):pli},{(xxxxxxxx):sp2}

Note: SP2 already setup without problem.

After SUBMIT and REBOOT. It seems ok. But, Obi start reboot once again (about 5 sec later) by itself. The setting is now back to DEFAULT. And the check box is also CHECKED.

Btw, already upgrade firmware to 1.3.0 (Build: 2651).  Any help? Thanks!

bubblestar

If you choose to tweak manually by yourself, it is suggested to disable:

System Management>>Auto Provisioning>>Method

Otherwise OBi110 will periodically check with the Web Portal and switch back to default or in line with the settings in the Web Portal.

If you keep the Auto Provisioning intact, you could go to the Web Portal and make the neccessary changes there directly.  In this case, it won't change your settings even periodically update is made.

ttmuskie

Thanks bubblestar!

Btw, instead of using the *xx as the prefix to dial the non-primary line, could I just by checking the length of the dial out number to determine which line to use?

bubblestar

Someone has worked out this before but I don't remember where it is (Maybe in OBihai Forum or somewhere in this forum under OBi section.)

It can be achieved by using the User Designed Digit Maps to determine and work with the Voice Gateway to dialout the call.