SPA3102已是四、五年前的產品吧! 估不到CISCO 仍為它更新Firmware，大品牌賣貴一些，有時真有其原因。
看過一下這新firmware，除了困擾大家的bug fix 之外，還有一些 enhancements。
Changes Since Firmware Version 5.1.10
Enhancements
• Add support for fetching admin/config.xml. The configuration file can be
retrieved by URL: http://ip_addr/admin/config.xml (where ip_addr is the
actual ip address of spa3102).
• Added an audio dump debug option. When Voice > System > Debug Option
is set to dbg_aud_dump, both the FXO port and the FXS port will start
sending audio data to the system log. Several .dat files will be added to the
syslog server directory. Configuring this setting to none will stop the audio
dump. It is best to enable this feature only when needed for debugging.
• Added DTMF playback twist on the the Voice tab > Regional page.
Added DTMF playback level&twist on the Voice tab > PSTN Line page.
(CSCtw71735)
Resolved Issues
• Fixed an issue in which Caller ID Failed. (CSCtb67946)
• Fixed an issue with detection of user inputs in the Interactive Voice
Response (IVR) unit. (CSCso34152)
• Fixed an issue in which a call through the PSTN caused all subsequent VoIP
or PSTN calls to get the reorder tone. (CSCtt69983)
• Fixed an issue in which the preferred codec setting was ignored.
(CSCtt70062)
• Fixed an issue in which a conference bridge could not be established by
using an account code. (CSCtu35079)
• Fixed an issue in which dialing did not time out properly after a user entered
invalid input. (CSCse53921)0
• Fixed errors with parameters whose Data Type is PhTmplt (such as Caller
Sel X Caller and Ring X Caller). (CSCsg45351)
• Fixed an issue in which T38 fax failed. (CSCsh94145)
• Fixed an issue in which fax transmissions failed at 14400 bps.
(CSCte53533)
• Fixed an issue in which changes in the QDisc setting did not take effect
during provisioning. (CSCth58164)
• Fixed an issue in which the line was not disconnected properly after the
remote end disconnected. (CSCtl92028) |
發表於 2012-3-5 13:02
|