角色

回復 268# ckleea

Is there any firmware in ext2 format available from Switchfin?

YH

ckleea

回復 271# 角色

I normally not keep the ext2 format except the latest one. Please also note that I do not know the ext2 flashing instruction for switchfin firmware. I believe it is different from ATCOM as the size is different. I briefly recall I did once before but failed. So I am a bit hesitate to do a firmware reflashing for switchfin.

角色

If u-boot is crashed, is there any means to recover it? I believe we have to open the ip-01 and locate the place for putting the JTAG. Is there any information about it?

YH

ckleea

I really don't know. But I saw a link to deal with this

http://www.fredshack.com/docs/atcom_ip01.html

角色

Thank CK. I hope ip-01 does have the pins for JTAG.

YH

ckleea

check this

http://www.rowetel.com/blog/?p=27

Qnewbie

回復 265# ckleea

I don't have further plan to upgrade IP01 to higher svn. Two most wanted features, i.e., callback and DISA are tested and they work. The only concern is the firewall issue. I put it behind thomson's modem+router gatteway and open ports in accordance with switchfin's recommendations. Hopefully the firewall in the gateway works.

yiucsw

下載 (3.32 KB)
trunk

2011-1-18 17:28

my active channel for IP01 seems dead, when dial, the following message appear in log.
"chan_sip.c: Call from '6002' to extension '9XXXXXXXX' rejected because extension not found"
Outgoing dail rule is set to trunk 1 dial pattern : "9XXXXXXXX"
any command line to debug the issue?

yiucsw

sorry just fix it. typo error.
working for VOIP trunk now.

bubblestar

Have you include your Outgoing Dialing Rules in your Dial Plan section??  This is one of the places we always forget to check with.

ckleea

So only 2 IP01 are not working, please let us know how we can help?

yiucsw

to add ET263 to IP01 SWITCHFIN, does it need to follow yhfung's method, edit
users.con ET263 registersip=no
sip.conf [general] context，
register=588034567:et263_password@sip.etelephone.cn:10002/588034567
? or any other easier way?
yes, i forget to add an _ in the outgoing plan

Qnewbie

1. system setup => Configure trunks
2. VOIP trunks => New SIP/IAX trunk
3. Fill the relative info:
Type: Sip
Provider Name: ET263
Hostname: sip.etelephone.cn : 10002
Username: 588012345
Authname: 588012345
Fromname: 588012345
Fromdomain: etelephone.cn
Password: yourSecret

Then Save&Apply changes

yiucsw

[attach]414[/attach]

unlucky

下載 (3.47 KB)

2011-1-18 21:34

[Jan 18 21:14:18] NOTICE[363] chan_sip.c: Peer '588060123' is now Reachable. (330ms / 2000ms)
[Jan 18 21:14:18] WARNING[363] chan_sip.c: Forbidden - maybe wrong password on authentication for NOTIFY
588060123 has no problem to log in by 3CX.
Any suggestion?

yiucsw

下載 (17.92 KB)

2011-1-18 21:37