返回列表 發帖

用sip reload去测试你的系统是否正常

本帖最後由 角色 於 2011-9-24 12:07 編輯

如果大家有时间做一个实验,就是在CLI mode,然后输入sip reload,请看下面:

TWTS119*CLI> sip reload
Reloading SIP
  == Parsing '/opt/etc/asterisk/sip.conf': Found
  == Parsing '/opt/etc/asterisk/users.conf': Found
  == Parsing '/opt/etc/asterisk/sip_notify.conf': Found

如果出现类似上面的信息,那么你的sip.conf基本上是没有问题。

注意我们要用Asterisk Console mode检测会比较好。

角色

should be no error or minimal warning. However, if your sip file is too big > 65k, you may have problems. In the pat, my sip conf file contains all the explanation, it fails to load.

TOP

sip reload will also cause re-registration for any peers you put in sip.conf.

TOP

If your sip.conf does not have problem, the registration will be very fast. Otherwise you have to check the sip.conf on line-by-line basis to find where gives the problem.

YH

TOP

返回列表