ckleea

你买的价唔错！差不多平一半

ckleea

最简单的备份方法是:

用ftp 进入 IP01, 系 /persistent/etc/asterisk 抄全部 conf files，同系 /var/log/asterisk 抄 master.csv

master.csv 装住的曾经 dial in and out records，所以如果你想保留，就抄低。

而 etc/asterisk 内的conf files，就帮你唔使再 config。

系GUI backup系可以，不过再抄出，就要到 /var/lib/asterisk/gui_backup directory， file format 系 tar

ckleea

In my box, it is at /var/log/asterisk/cdr-csv

ckleea

Or /persistent/var/log/asterisk/cdr-csv

ckleea

你的IP01 box LAN LED on or not.

Hook up your serial console, see if it is booted.

If boot, login in as root/uClinux
issue command, ifconfig to see the IP.

If you found the IP, use the command:
ifconfig eth0 192.168.8.100 netmask 255.255.255.0 (or your LAN netmask);
recheck with ifconfig to confirm correct IP;
after that you can now see the GUI from browser as 192.168.8.100

You may also need these commands if you find some error in boot
chmod +x /persistent/etc/init.d/dahdi
chmod +x /persistent/etc/init.d/vlan

/persistent/etc/init.d/dahdi disable
/persistent/etc/init.d/vlan disable

rm /persistent/etc/rc.d/S55vlan

/persistent/etc/init.d/dahdi enable
/persistent/etc/init.d/vlan enable
ls -al /etc/rc.d/

sync
reboot

If the IP0x box LAN LED is off and no boot message found in the serial console, go for recovery.

ckleea

你應該改為 uImage, 然後 reboot,

If ok, GUI will be switchfin

ckleea

No need, just uImage is ok

ckleea

You need recovery. Follow the manual and use atcom ext2 firmware

ckleea

恢复过8次左右了，，每次升级switchfin都不成功  我仲系用返ip01的算了
lttliang 發表於 2010-11-26 16:16

Did you try GUI update via ATCOM?

ckleea

應該得，不過可以試下我再舊D switchfin firmware。請收電郵。

ckleea

If you still can't make it work, please pass your IP01 to me.

ckleea

Can you get ATCOM GUI back?

ckleea

Remote access has difficulty.

Let me check further on the old switchfin firmware available.

ckleea

基本上，你已經掌握救機的程序，只是上唔到switchfin，你可再試用 ATCOM GUI，upload新的switchfin firmware。昨晚傳給你的firmware 應該OK，我都係用嗰個firmware 幫bubblestar upgrade。你用邊個tftpd，免費嗰個就得！

ckleea

查收電郵