我的Asterisk 1.8开始启动了 - Asterisk - VoIP 研究室 - 電訊茶室

Rank: 1

1^# 跳轉到 »

發表於 2011-1-19 22:56 | 顯示全部帖子

CLI> core show version

Rank: 1

2^#

發表於 2011-1-19 22:58 | 顯示全部帖子

yum upgrade 定係 yum update ?

新 install 定係由 Asterisk 1.4 或 Asterisk 1.6 用 Yum?

Rank: 1

3^#

發表於 2011-1-20 11:39 | 顯示全部帖子

Strangely, when I made the build for GUI, it was clearly stated SVN-branch-2.0-r5144 dew days ago. However, when entering the GUI, it shows:

Asterisk Build:
Asterisk/1.8.2
Asterisk GUI-version : SVN-branch-2.0-r5143

Rank: 1

4^#

發表於 2011-1-20 11:48 | 顯示全部帖子

Yes, I did.

cd /usr/src
svn co http://svn.digium.com/svn/asterisk-gui/branches/2.0 asterisk-gui
cd asterisk-gui
sh configure && make && make install

Rank: 1

5^#

發表於 2011-1-20 12:48 | 顯示全部帖子

However, I have signal problem to indicate whther the extension is occupied or not. No matter the extension lines are on or off. It shows green light. No yellow or red light is shown on GUI. In this regard, it is meaningless and useless if I lose monitoring purpose, for the time being.

Rank: 1

6^#

發表於 2011-1-20 12:51 | 顯示全部帖子

回復 19# ckleea

Shall I need to remove the old GUI first before another try or just cover the new version on the existing one.

Rank: 1

7^#

發表於 2011-1-20 13:31 | 顯示全部帖子

Thanks and will try later.

Rank: 1

8^#

發表於 2011-1-21 09:57 | 顯示全部帖子

Is your on / off status just delay showing in the GUI or not function? Mine is always in green no matter the line is used or not. I think it is the signal detection problem.