bubblestar

Thanks for sharing.

I have tried that before and it was also a success.  

Do you know if can we do that in the same network environment with 2 Asterisk servers?  My trial was fail.

bubblestar

Mine is Vigor 2930n.  It should not have much difference but I failed to do it for dual servers in same lan environement.  Hope you can make it and enlighten me the way to get it work.

bubblestar

Basically, the internal/external using the default UDP5060 is no problem.  If I use single server, I can still connect it from outside world with port 15060.  However, when I set up another (2nd) Asterisk server in the same lan, I cannot use other ports like 25060 to re-direct to the internal 5060 on the second server.  That's my existing situation.  

Anyway, Draytek Vigor 2930n is a good router for me, so far.  Maybe, I have to spend some time to get familiar with it further.

bubblestar

回復 14# ckleea



A very good set up advice.  Thanks.

I have been puzzling about the question that when I set up new trunks using APL, there is no way for me to see the trunk in Outgoing Calling Rules and Incoming Calling Rules in the GUI interface.  In this case, how can I create DP for the newly established trunks?

OK.  If I set up all IN/OUT calling rules with APL as well.  I'm still unable to see the trunk status from GUI.  Is that normal?  Are you just living with that and dial out by memorizing dialing prefix without the need to refer to GUI?

Another question is that I discover there is no crontab under the  /persistent/etc/ directory.  Shall I need to create one myself to do crob job?

bubblestar

Thanks for your explanation and example.  Will follow suit accordingly.

bubblestar

Thanks! 一直追求自動化，來到半場，仍然要手動完成某些工作， 有時想起來的確有趣。