電訊茶室 - Powered by Discuz! Board

標題: phicomm N1 install Armbian 20.10 [打印本頁]

作者: yiucsw 時間: 2020-1-4 03:18 標題: phicomm N1 install Armbian 20.10

本帖最後由 yiucsw 於 2020-12-1 21:41 編輯

Phicomm N1 要有 Remote control, USB 手指 8G+
https://www.right.com.cn/forum/f ... ypeid%26typeid%3D21

1. 下载Armbian:

https://users.armbian.com/balbes150/arm-64/[/url]

複製代碼

选择：Armbian 20.09

2. Click file .img.xz unzip to .img

sudo dd if=./Armbian_20.09_Arm-64_focal_current_5.8.10.img of=/dev/rdisk2 bs=1m

複製代碼

3. 修改 default -> boot Phicomm N1 file.
3.1 XX Remount USB -> R/W

diskutil unmountDisk /dev/disk2
[code]sudo mkdir /Volumes/BOOT
sudo mount -w -t msdos /dev/disk2s1 /Volumes/BOOT
cd /Volumes/BOOT

複製代碼

作者: yiucsw 時間: 2020-1-4 04:08

本帖最後由 yiucsw 於 2020-12-2 00:51 編輯

ssh to N1. look at N1 display output there is an IP address show. or check IP from router.
Run

armbian-config

複製代碼

-
Network

-Change eth0 to static (sudo nano /etc/network/interfaces)
-Disable IPV6
-Enable WIFI
-Install Bluetooth (if there is Bluetooth keyboard/mouse)
System
- Disable Desktop (if select Desktop linux) low memory and enable if needed.

Network Static ip
sudo nano /etc/network/interfaces

iface eth0 inet static
address 192.168.1.100
netmask 255.255.255.0
gateway 192.168.1.1

作者: yiucsw 時間: 2020-1-4 15:34

本帖最後由 yiucsw 於 2020-1-9 17:00 編輯

Install Docker and portainer
https://leeyr.com/324.html

作者: yiucsw 時間: 2020-1-6 11:22

本帖最後由 yiucsw 於 2020-1-9 17:05 編輯

Install docker management: portainer

docker pull portainer/portainer:latest
docker run -d -p 9000:9000 -p 8000:8000 --name portainer --restart always -v /var/run/docker.sock:/var/run/docker.sock -v portainer_data:/data portainer/portainer

複製代碼

in Brower url: ipaddress:9000 for portainer interface
from https://portainer.readthedocs.io/en/latest/deployment.html.

作者: yiucsw 時間: 2020-1-9 17:15

本帖最後由 yiucsw 於 2020-12-2 00:52 編輯

reserved this page

作者: yiucsw 時間: 2020-2-21 19:43

本帖最後由 yiucsw 於 2020-2-25 18:06 編輯

deleted, refer to T1

歡迎光臨電訊茶室 (http://telecom-cafe.com/forum/)