You might forget to set up the inbound dialplan.作者: bubblestar 時間: 2012-7-14 13:59
本帖最後由 bubblestar 於 2012-7-14 14:02 編輯
User is a type you use for your local SIP phones.
As of Asterisk 1.2, there is no reason to actually use 'user' entries
any more at all; you can use 'type=peer' for everything and the behavior
will be much more consistent.
All configuration options supported under 'type=user' are also
supported under 'type=peer'.
The difference between friend and peer is the same as defining _both_ a
user and peer, since that is what 'type=friend' does internally.
The only benefit of type=user is when you _want_ to match on username
regardless of IP the calls originate from. If the peer is registering to
you, you don't need it. If they are on a fixed IP, you don't need it.
'type=peer' is _never_ matched on username for incoming calls, only
matched on IP address/port number (unless you use insecure=port or higher).
電話號碼及密碼用x代替)