你指Asterisk? 在CLI下輸入sip show registry.作者: ttmuskie 時間: 2012-3-18 22:54
本帖最後由 ttmuskie 於 2012-3-18 22:56 編輯
yes asterisk, but not under cli. i want to check inside the dialplan. if the trunk is not registered, then i will use another trunk.作者: 雯雯 時間: 2012-3-18 23:04
I'm currently setup the superdial already. But it just seems take a while (~5 - 10 sec) to check if the truck is "failed". So, for that 5 - 10 sec, I got "dead air" on my phone. Then I will get ringing tone again once it jumped to the working trunk. That's why I try to eliminate the dead air.作者: 雯雯 時間: 2012-3-19 10:14
It is not normal to take more than 5 seconds for checking. In my case, I have set 8 different trunks in different devices. It takes about 3 to 5 seconds to determine the available trunk to dial out.
My trunks inlcude ATAx2, DAHDI, OBi110, OBiApp, 2bApp, USB Dongle and IP01.
Are you using the same SuperDial script as ckleea and I are using?作者: ckleea 時間: 2012-3-20 21:47
