標題: Obi110 SP1 cannot resolve ip address with DynDNS [打印本頁] 作者: Qnewbie 時間: 2011-7-4 18:49 標題: Obi110 SP1 cannot resolve ip address with DynDNS
Finally I got Obi110 in my hand.
The Obitalk and device registeration went smoothly. However, the registration with my IP01, whose ip is located with dynDNS.
The configuration is done thru Obitalk portal, and the result is:
Register Failed: Server Not Reachable (server=0.0.0.0:5060; retrying)
Anyone encouters this problem?作者: bubblestar 時間: 2011-7-4 22:12
If all the network devices including IP01 + OBi110 are in the same LAN behind your Router, I think the best way is to set DynDNS only in Router.
In my case, both IP01 + OBi110 are using internal IP address 192.XXX.XXX.XXX instead of real IP. DynDNS is being handled in the Router.作者: Qnewbie 時間: 2011-7-4 23:26
This is a bug, which should be fixed by Obi作者: cccttam 時間: 2011-7-5 00:08
I have the same problem. Solved by intranet with intranet with IP address (192.168.x.x) and internet use DynDNS address. IP01 must set to NAT mode= Yes, Allow RTP Reinvite = Yes on SIP setting.作者: Qnewbie 時間: 2011-7-5 09:10
It is a stupid bug as ancestor SPAxxxx can resolve dynDNS without any problem
