bubblestar

Strangely, when I made the build for GUI, it was clearly stated SVN-branch-2.0-r5144 dew days ago.  However, when entering the GUI, it shows:

Asterisk Build:
Asterisk/1.8.2
Asterisk GUI-version : SVN-branch-2.0-r5143

ckleea

You download from the release source and so you got 1.8.2. Mine is from subversion that would get update almost daily.

Did you make an make install after make?

bubblestar

Yes, I did.

cd /usr/src
svn co http://svn.digium.com/svn/asterisk-gui/branches/2.0 asterisk-gui
cd asterisk-gui
sh configure && make && make install

ckleea

回復 18# bubblestar


    Try again. Mine is now 5145. You can it includes setting for Gtalk

角色

Is there any problems encountered when you used the GUI for Asterisk 1.8?

YH

ckleea

回復 20# 角色
So far so good. As stated before, most of the time to use GUI is to check the online and offline status and CDR. The CDR prompts me to identify hacker from Palestainin.
I seldom use GUI to do other thing except as monitor.

bubblestar

However, I have signal problem to indicate whther the extension is occupied or not.  No matter the extension lines are on or off.  It shows green light.  No yellow or red light is shown on GUI.  In this regard, it is meaningless and useless if I lose monitoring purpose, for the time being.

bubblestar

回復 19# ckleea


    Shall I need to remove the old GUI first before another try or just cover the new version on the existing one.

ckleea

回復 23# bubblestar


    Just make install is ok. It will overwrite your files.

bubblestar

Thanks and will try later.

ckleea

回復 22# bubblestar

I also notice the delay in changing the on / off status in the GUI.

bubblestar

Is your on / off status just delay showing in the GUI or not function?  Mine is always in green no matter the line is used or not.  I think it is the signal detection problem.

ckleea

It changes to red upon dialing or on hook.  Also it will be appear when login.